The fields on the right-hand side in the “Event” view are used to specify which object the event should be linked to.
In the “Doc.” field you enter the name of the document where the LP model of interest is stored. This document should always be open when you run a simulation. If you leave this field blank, DynLP will assume that the LP model is located in the document you opened first in the current DynLP session. Thus, unless you always open just one DynLP document at the time, you should enter a document name in the “Doc.” field.
In the “Table” field you enter the name of the table you want to link to, i.e., “S”, “C”, “X”, “A”, or “B”.
Finally in the “Row” and “Cell” fields you enter respectively the row and column number of the cell you want to link to.
